User's Manual Part 1
Table Of Contents
- 1: Introduction
- 2: Product Overview
- 2.1 Introduction to the workflow interface
- 2.2 Product overview
- 2.3 General product handling and operation
- 2.3.1 Protection from water and dust ingress
- 2.3.2 Important battery charging note
- 2.3.3 Powering on/off
- 2.3.4 Attaching the strap
- 2.3.5 About the touchscreen display
- 2.3.6 Selecting the active interface
- 2.3.7 Running a function or test
- 2.3.8 Repeating a function or test
- 2.3.9 Screen title bar buttons/icons
- 2.3.10 Capturing a screen image (screenshot)
- 2.3.11 Stopping a test
- 2.3.12 Saving results
- 2.3.13 Maximum test duration for continuous tests
- 2.3.14 Interpreting results
- 2.4 Handling the MoCA/RF module
- 2.5 Remote control of the unit
- 2.6 Licensed feature details
- 2.7 Maintenance
- 2.8 FTP information
- 2.9 Technical support
- 3: Wi-Fi Testing Menu
- 4: 10/100/1G Testing Menu
- 5: System Menu
- 5.1 Record Manager
- 5.2 Admin Port
- 5.3 Set Date and Time
- 5.4 Version Info
- 5.5 Battery Status
- 5.6 Video
- 5.7 Cal Touchscreen
- 5.8 Licensed Options
- 5.9 Update Firmware
- 5.10 System/Module Settings
- 5.10.1 System/Module Settings > Base Unit
- 5.10.2 System/Module Settings > RF Video Module
- 5.10.3 System/Module Settings > ADSL/VDSL2 Module
- 5.10.4 System/Module Settings > Combined Module Default
- 5.10.5 System/Module Settings > MoCA Module
- 5.10.6 System/Module Settings > DOCSIS Module
- 5.10.7 System/Module Settings > CSM Module
- 5.10.8 System/Module Settings > MoCA-RF Module
- 5.10.9 System/Module Settings > Wi-Fi
- 5.11 Signature Capture
- 5.12 Language Selection
- 5.13 Help and Support
- 5.14 System Information
- 5.15 Wizard GUI
Tech-X Flex
®
(NG2) Tech-X Flex User Guide - Firmware v06.50
2-7
Intro
Overview
Wi-Fi
Ethernet
System
IP/Video
MoCA
RF
Specs
Assuming that WAN throughput is acceptable and you are ready to continue, the workflow moves to its
second major stage, LAN testing. To complete the workflow, independent testing must be run at the
location of each Wi-Fi client (STB, computer, etc.), or any other location where you want to verify the
service. Before this testing proceeds, the workflow requests the selection of either Video or Data:
Figure 2-9 Wi-Fi INSTALLATION workflow - Installation type selection
The primary difference between these options is the pass/fail thresholds applied to the results. The
testing procedure is the same for both, where you should:
1. Move the unit to an appropriate testing location; that is, a place where Wi-Fi performance is
important.
2. In the workflow setup, specify a “name” (Room) for the location, which serves as an identifier within
the results only.
3. Initiate the testing and wait for it to finish.
4. Repeat this procedure for all desired testing locations.
Figure 2-10 Wi-Fi INSTALLATION workflow - Room label selection
Preliminary issue - Limited distribution only!