Instructions / Assembly
Table Of Contents
- Slide 1
- Slide 2
- Slide 3
- Slide 4
- Slide 5
- Slide 6
- Slide 7
- Slide 8
- Slide 9
- Slide 10
- Slide 11
- Slide 12
- Slide 13
- Slide 14
- Slide 15
- Slide 16
- Slide 17
- Slide 18
- Slide 19
- Slide 20
- Slide 21
- Slide 22
- Slide 23
- Slide 24
- Slide 25
- Slide 26
- Slide 27
- Slide 28
- Slide 29
- Slide 30
- Slide 31
- Slide 32
- Slide 33
- Slide 34
- Slide 35
- Slide 36
- Slide 37
- Slide 38
- Slide 39
- Slide 40
- Slide 41
- Slide 42
- Slide 43
- Slide 44
- Slide 45
- Slide 46
- Slide 47
- Slide 48
- Slide 49
- Slide 50
- Slide 51
- Slide 52
- Slide 53
- Slide 54
- Slide 55
- Slide 56
- Slide 57
- Slide 58
- Slide 59
- Slide 60
- Slide 61
- Slide 62
- Slide 63
- Slide 64
- Slide 65
- Slide 66
- Slide 67
- Slide 68
- Slide 69
- Slide 70
- Slide 71
- Slide 72
- Slide 73
- Slide 74
BURNERS
Cleaning Method:
◼ Clean the exterior of the burner with a wire brush.
◼ Clear any clogged burner ports with a straightened paper
clip.
◼ Do not use a toothpick as it may break off and clog the
port.
◼ Check and clean burner/venturi tubes.
1. Remove grill grates and flame tamers.
2. Remove the 2 screws and cotter pin that hold the burner in
place. Remove gas burner from the grill.
3. Use a flashlight to inspect into the burner through the
burner inlet to ensure there is no blockage. If any
obstruction is seen, use a metal coat hanger that has been
straightened to clear them.
4. After inspecting the inside of burner for blockage,
reassemble burner by sliding the middle tube of the gas
burner over the gas orifice.
5. Reattach gas burner using screw.
32
REAR BURNER
Cleaning Method:
1. Light the real burner. See the “Using Your Rear Burner”
section.
2. Close the grill hood.
3. Leave the burner on high for approximately 30 minutes.
4. Turn knob to OFF and let cool completely.
5. Brush off ash particles from the top sear burner.
GREASE MANAGEMENT SYSTEM
IMPORTANT: The grease tray should only be removed when
grill is completely cool.
The grease tray collects grease and food particles that fall
through the grill. Clean often to avoid grease buildup.
Cleaning Method:
◼ Remove the grease tray from the grill and remove the heat
tent from the tray.
◼ Wipe excess grease with mild detergent and warm water
by using paper towels.
◼ Rinse and dry thoroughly.
◼ Replace heat tent to grease tray and insert the grease tray
to the grill.
KNOBS AND FLANGE AREA AROUND KNOBS
IMPORTANT: To avoid damage to knobs or flange area
around knobs, do not use steel wool, abrasive cleaners, or
oven cleaner.
Do not soak knobs.
Cleaning Method:
◼ Mild detergent, a soft cloth and warm water.
◼ Rinse and dry.
CONTROL PANEL GRAPHICS
IMPORTANT: To avoid damage to control panel graphics, do
not use steel wool, abrasive cleaners or oven cleaner.
Do not spray cleaner directly onto panel.
Cleaning Method:
◼ Clean around the burner labels gently; scrubbing may
remove printing.
◼ Mild detergent, soft cloth and warm water.
◼ Rinse and dry.
STONE PANEL
Cleaning Method:
◼ Do dust surface frequently.
◼ Clean panel with water and mild detergent.
◼ Do not use any cleaning chemical to clean the stone panel.
◼ Do not use vinegar, mix bleach or bathroom cleaner to
wash the stone panel.