Operation Manual

3
HOW TO USE YOUR VECTRON
®
WAVE
12
4 5
CHG/OFF/ON
CHG/OFF/ON
1. Turn your Vectron
®
Wave “ON”. After a few seconds
the propeller will begin to spin.
CAUTION: Rotating propellers, please use care
when handling.
2. Set your Vectron
®
Wave on a flat surface or the ground.
NOTE: Your Vectron
®
Wave will go through a “Start-Up
Process” at this point. First it will rise up, then it will
slowly fall, then it will rise up again. This helps it to
memorize the power required to hover on its’ own.
After it rises the second time the process is over and
you can begin to play. NOTE: During this process do not
touch or play with your Vectron
®
Wave as this will make
its’ hovering ability unstable.
3. Hand Play: The Vectron
®
Wave will hover above your
out-stretched hand.
4. Sliding or Tossing: Hold the Vectron
®
Wave by the
catching stick and tip forward 10-30°. Toss or slide gently
to another player.
5. When finished playing press the stop button on the
charger to turn the propeller “OFF” then turn the power
switch on the Vectron
®
Wave to “OFF”.
NOTE: If the Vectron™ Wave tips over or sticks to the ceiling,
use the STOP button on the charger to stop the propeller.
After pressing the stop button on the controller, the Vectron™
Wave will slow down and settle to the ground.
TROUBLESHOOTING
Charger LED is OFF
(not flashing).
Stop button is not working.
Charger LED is flashing Red/
Green alternatively while
charging Vectron
®
Wave.
1. Charger may be in sleep mode
(enters sleep mode after about
2 minutes of inactivity).
2. The batteries in the charger are drained.
1. Vectron
®
Wave is out of range.
2. Charger is in sleep mode.
1. Error while charging.
1. Turn charger OFF then ON again.
2. Install new batteries in charger.
1. Move charger closer to the
Vectron
®
Wave.
2. Turn charger OFF then ON again
or press stop button again.
1. Check that the connection between
the charger and the Vectron
®
Wave
is not broken, if it is reconnect.
PROBLEM
SOLUTIONCAUSE
3
Beginning of
“Start-Up
Process”
Finished,
Ready to
Play