Operation Manual

2
CHARGING YOUR VECTRON
®
WAVE
1. Open door in charger to access the charge cable.
2. Plug charge cable into the charge port on Vectron
®
Wave.
3. Set switch on Vectron
®
Wave to charge.
4. Set switch on charger to charge. The Power LED Indicator on the charger
will turn red and flash. When the Vectron
®
Wave is fully charged the Power
LED Indicator will turn orange. This may take up to 30 minutes or longer if
the Vectron
®
Wave is fully discharged and the charger batteries are not new.
After fully charging, you should have about 5 minutes of play time.
NOTE: For better flight performance, fully charge your Vectron
®
Wave
before each flight.
CHG/OFF/ON OFF ON/CHG
1
2
34
AFTER CHARGING IS OVER
OFF ON/CHG
12
1. Set switch on charger to “OFF”.
INDOOR USE ONLY
1. Location – Fly in a wide open room, away
from breakable items. Minimum size 13 ft wide x
13 ft long x 10 ft high.
2. Avoid flying near vents and/or fans, as these
may overpower the Vectron
®
Wave and make it
difficult to control.
3. Sunlight or bright lights may affect your Vectron
®
Wave’s performance.
4. Avoid flying near another IR device. This may
affect your Vectron
®
Wave’s performance as well.
NOTE: Always get permission to fly your Vectron
®
Wave indoors.
2. Remove charge cable from
Vectron
®
Wave and store in charger.
CAUTION: Never fly near your face. Keep rotor
away from your fingers, hair, eyes and other body parts.
Always lift off from a flat surface. Never hold the Vectron
®
Wave in your hand when lifting off. DO NOT launch
Vectron
®
Wave near people or animals. Stay away from
obstacles and electrical hazards.
13’ 13’
10’