User's Manual


14
TemporaryandPermanentProgramming
Whenever a change is made to aparameter value orother data field while the NS iswithin telemetry
range, this value immediately becomes temporarily active
. The corresponding value or data selection
appearinaredboldunderlinedfont.
Temporaryprogrammedvaluesortextdatacanbepermanentlyprogrammed
bypressingtheprogram
button.Thefontcolorchangesfromredtoblack.
NOTE:WhenleavingaWorkspacewhilevaluesaretemporarilyactive
youwillbepromptedtoeither
programthesevaluespermanentlyorcancelthependingchanges.
NOTE:ParameterscanbetemporarilyactiveonmultipletabsofthesameWorkspace.
Moreoneditingtextfields
NOTE:Selecting a text field will pop up a keyboard at the bottom of the screen, allowing the
informationto berevised.Toclose the keyboardafter modifying the entry,pressthe keyboardkey
centeredinthebluebaratthebottomofthescreen.
Whiletextfieldsarebeingedited
theyappearinablackbold
font(nounderline).Atthesametimetotherightofthetext
fieldareddotisshownindicatingthateditingisinprogress.
Editing can be in progress for multiple fields at the same
time.
Onceeditingforafieldiscomplete,
tapthered‐dottomake
the change temporarily active
. The red dot disappears and
thefontchangesfromblackboldtoredboldunderlined.
Onlyuponpressingtheprogrammingbuttondoesthechange
become permanently programmed
 and the font color
changesfromredtoblack.
