User's Manual


12
6. MovetheClinicalProgrammermagnetovertheNSdeviceinacircularmotiontoconnect.
The indicator status bar on the bottom left of the screen will  display “Connected” if the connection
attemptis successful.IftheProgrammercouldnotcommunicatewiththeNSdevice,anerrormessage
willappear
and“Disconnected”willbedisplayedinthestatusbar.
NOTE:Ifafter2minutestheClinicalProgrammerhasfailedtocommunicatewiththeNSdevice,the
programmer will automatically cancel the connection attempt. Try to commu nicate with the NS
device by pressing the “Connect” button again moving the magnet symbol
on the Clinical
ProgrammerovertheNSdeviceinacircularfashion.
Whenasuccessfulconnectionisestablished,theProgrammerchimesandtheNSdevicewillbequeried.
7. ForthedurationoftheprogrammingsessionkeeptheClinicalProgrammerwithin6feetofthe
NSdevice.Movingtheprogrammertoo
farawaymaycausetelemetryconnectiontobelost.
BacktoMainMenu
LocatedatthebottomrightsideoftheProgrammerConnectwindow,the“Exit”buttonisusedtoreturn
totheMainMenu.
Navigationandscreenelements
NeurostimulatorDashboard


Once the selected NS device is connected to the Clinical
Programmer,theNSDashboardisdispl a yed inthescreen’s
headerproviding:
• PatientID:thepatient’sIDNumber.
• Stimulator Serial Number: the NS device’s serial
number.
• Alerts button: The button turns orange when any
ofthe NSSystemAlertsbecomeactive.Whenthe
“Alerts” button is orange, press the button to
displaya windowshowingdetails ofallthe System
Alerts.An example of the screenshot is shown to
theright.
