User's Manual


10
ProgrammerPowerUp
TurntheClinicalProgrammerONbypressingthe““button.TheMainMenuwillbedisplayed.
NOTE:If the ClinicalProgrammer screen does not turnon, follow the instructions for charging the
battery,andtryagain.
MainMenu
TheMainMenudisplaysthreeprimaryfunctions:
• Demo:Putsthesystemintoastand‐alonedemomode
allowing you to use all programmer functions without
itbeingconnectedtoaNS.
• Programmer Setup:Allows you to set the Clinical
Programmer date and time, activate the FCE
Workspace on the
 Programmer, and set and modify
theProgrammerpassword.
• ConnecttoStimulator:Opensascreenthatallowsyou
tocommunicatewiththeNSdevice.
TheMainMenuidentifiesthedeviceastheSpinalModulation
Clinical Programmer.Furthermore, Programmer’s Serial
Number,SoftwareVersion,BasestationFirmwareVersionandManufacturingdatearedisplayed.
Atthe bottomofthe Main Menu,the status bar displaysthe Programmer – NS connection status, the
battery charge level and the time. Refer to the section on the Programmer Status Bar in this User
Manual.
Demo
Select“Demo”onthe Main Menu toinitiate Demo mode.
Buttons will be purple to indicate that the Programmer is
operatinginDemo mode.NoNSdeviceisneededforthis
mode —just the Programmer. The Pr ogrammer will have
simulated NS data on it and will simulate the RF communication with
 the NS. This means that at the
startofeveryDemosession,thedatawillalwaysbethesame.
ProgrammerSetup
Select “Programmer Setu p”  on the Main Menu to get the
setupscreen.
