Installation Guide
Table Of Contents
- About this Manual
- Product Overview
- Radio Node Models
- Antennas
- System Specifications
- Compliance
- Radio Specifications
- Ports
- The Top-Panel LED
- Input Power
- Select the Radio Node Location
- Installation and Mount Bracket Assembly
- Boot Sequence and Services Node Communication
- Radio Node LED Boot Sequence
- Radio Node LED Management
- The SpiderCloud Documentation Set
- LTE Antenna Patterns
SpiderCloud Radio Node - SCRN-340 Hardware Installation Guide
17
Step 2 Route the Ethernet cable through the rectangular hole in the mounting bracket.
Figure 12 Mount Bracket with Direct Cable Routing
Step 3 With two user-provided screws, attach the mount bracket assembly to a wall or ceiling. The
screw holes are sized for an M4 (#10) or larger screw. Ensure the screws have a snug fit onto
the studs, sheetrock, anchor, or other material you are bolting onto and that you match the
screw head with the appropriate cutout hole size on the bracket.
If needed, use a flat washer between the bracket and screw head to ensure a secure fastening.
Step 4 Insert the RJ-45 connector into the Ethernet port as shown in Figure 13:
Figure 13 Route and Terminate the Cable
Ethernet Cable
Entry Hole
DRAFT