Installation Manual

SpiderCloud Radio Node - SCRN-320 Hardware Installation Guide
11
The illustration below shows a generic single-port PoE+ injector. Use this injector only when a PoE+
Ethernet switch is not available.
Figure 9 Typical PoE+ Injector
To connect the PoE+ injector to a radio node
Step 1 Attach the injector power cord to a power source.
Step 2 Connect an unpowered Ethernet cable from a switch to the IN port on the injector.
Step 3 Connect an Ethernet cable from the injector’s OUT port to the radio node. The injector will
now inject power onto a pair of wire pairs in the cable. The radio node will expect a nominal
48V DC input (57V max) from a typical PoE+ injector.
System Specifications
The SCRN-310 radio node has the following chassis measurements, power requirements, and
environmental requirements, and complies with the following standards. Refer to the feature guide for your
services node software release for release-specific features and specifications.
Table 2: Radio Node Specifications
Dimensions Height:1.82 cm (7.2 in.)
Width: 1.82 cm (7.2 in.)
Depth: 4.4 cm (1.7 in.)
Weight 1.13 kg. (2.5 lbs)
Active Sessions
per Radio Node
Up to 64 active LTE users
Peak Data Rate Downlink 300 Mbps; Uplink 50 Mbps (at 20 MHz)
Voice Services VoLTE; 4 data bearers per UE
Power
Requirements
Licensed: Maximum transmit power: 2x125 mW (24 dBm)
Unlicensed: Maximum transmit power: 2x250 mW (27 dBm)
Input Power Power over Ethernet (PoE+) draws approximately 18W
Channel Size Licensed: 5, 10, 15, 20 MHz
Unlicensed: 20 MHz
OUT
IN
CONNECT
PoEPLUS
ON
DRAFT
SpiderCloud Wireless, Inc. Proprietary and Confidential