User's Manual
Table Of Contents
- Table of Contents
- About this Manual
- System Overview
- System Specifications
- Radio Node Models
- Antennas
- Ports
- The Top-Panel LED
- Input Power
- Select the Radio Node Location
- Installation and Mount Bracket Assembly
- Boot Sequence and Services Node Communication
- Radio Node LED Boot Sequence
- Radio Node LED Management
- The SpiderCloud Documentation Set
- Appendix A: UMTS Antenna Patterns
- Appendix B: LTE Antenna Patterns
SpiderCloud Radio Node - SCRN-310 Hardware Installation Guide
SpiderCloud Wireless, Inc.
15
Figure 12 Fully Mounted
Installing the Radio Node (Method 2)
To route the cable directly and mount the radio node
Step 1 Route the Ethernet cable through the large hole in the mounting bracket.
Figure 13 Mount Bracket with Direct Cable Routing
Step 2 With two user-provided screws, attach the mount bracket assembly to a wall or ceiling. The
screw holes are sized for an M4 (#10) screw. Ensure the screws have a snug fit onto the
studs, sheetrock, anchor, or other material you are bolting onto.
Step 3 Insert the RJ-45 connector into the Ethernet port as shown in Figure 14:
Transmit Side