User's Manual

SpiderCloud Radio Node - SCRN-200 Hardware Installation Guide
SpiderCloud Wireless, Inc.
10
Figure 5 Ethernet Port
The radio node for use with external antennas has two antenna ports with TNC connectors labeled A
and B. Connector A transmits and receives. Connector B is receive only.
Figure 6 Antenna Port TNC Connectors
The Top-Panel LED
The radio node has one top-panel tricolor LED to indicate power and status. This is the only LED visible
under normal operating conditions.
Figure 7 Radio Node Tricolor LED
When the radio node initially boots the LED cycles through a number of colors and flashing behaviors until
it is fully operational. Refer to Radio Node LED Boot Sequence on page 20 for more information about the
LED boot cycle and Radio Node LED Management on page 21 for information about LED management.
Input Power
The radio node receives its power from a standard PoE+ switch (typical) or injector. The radio node is fully
compliant with the IEEE 802.3at Power Over Ethernet (PoE+) specification. SpiderCloud Wireless
recommends PoE+ powering to support future products and functionalities operating at higher power
levels.
Ethernet
Port
Link
Activity
AB
LED