User guide

Capscrew Fastener Locations for 23105 Family Models:
Shown on the left hand side of the chart below are the carrier-to-housing fastener configurations for the 23105
Family Drive Axles built with the new Thick Flange Carriers. Shown on the right hand side of the chart are the
fastener locations for models built with the original “Thin” flange mounting flange carriers.
*GM vehicles will continue to use the “original” design carriers until Mid-2003.
23105S/D/A
26105S/D/A
30105S/D/A
C C
B B
B B
B B
B B
C C
HEAD TO HOUSING HEAD TO HOUSING
23105S/D/A
26105S/D/A
30105S/D/A
B B
B B
B B
B B
B B
B B
NEW
“THICK FLANGE”
FASTENER CONFIGURATION
(AFTER 1/6/03)
ORIGINAL THIN FLANGE
DESIGN FASTENER
CONFIGURATION
(BEFORE 1/6/03*)
A - 130877 Flat Washers – All Locations
B - 130185 Capscrews – Short (55mm)
C - 130218 Capscrews – Long (80mm)
VIEW – LOCATION OF FASTENERS ARE VIEWED AS IF INSTALLING DIFFERENTIAL INTO THE AXLE HOUSING.
For spec’ing or service assistance, call 1-800-621-8084 24 hours a day, 7 days a week,
Or visit our web site at:
www.spicerparts.com
Dana Corporation
Copyright Dana Corporation, 2003 Commercial Vehicle Axle Division
April 2003 All Rights Reserved. P.O. Box 321
Printed in U.S.A. www.dana.com
Toledo, Ohio 43697-0321
4