User's Manual

39
4 Assembly and installation
4.1 Installation location requirements
 Ambient conditions must be complied with  Chapter 2.2
 Connecting cables for connecting the various components must be in place.
 The line voltage must comply with the specifications of the power supply being used.
For further information observe the power supply’s operating instructions.
 Customer-provided power cable type: 0,13 – 0,52 mm
2
4.2 Assembly and installation of the WT 210
Personnel:
 Electrical expert
Requirements:
 There is a pre-installed DIN 49703 switch box in the wall at the required installation location.
 The cable for the power supply, the cable to the electric strike and for the optional pushbutton have already
been routed.
1.>
Disconnect power at the mains end.
2.>
Screw frame of WT 210 to the pre-installed switch box. Make sure that the support rails (1) for the terminal
are on the right and left, and that the black marking (2) is above.
Fig. 5 Frame, front view with top marking