User Manual

05
SPEX BACK SUPPORT USER MANUAL 9
WWW.SPEXSEATING.COM
Insert Back Support into the hooks. Level
the clamps so the Back Support sits
squarely between the canes.
Backrest should clip in securely into both
quick release catches.
The angle of the Back Support can be
adjusted by loosening the two Stainless M8
Dome Nuts on each mount.
8.
9.
10.
To adjust the angle, use a 13 mm wrench to loosen
the M8 nuts enough until the bracket is free to move.
Retighten once the Back Support is at the correct
angle.
11.
12.
13.
To increase the seat depth of the seating system the telephone
shaped bracket can be rotated about as shown.
The quick release mechanism and hook will be required to
swap positions on the bracket as shown.
RIGHT HAND ASSEMBLY SHOWN.
SINGLE-
MOUNT
D UA L-
MOUNT
Telephone shaped handle bracket mounted in forward position
for less seat depth.
Telephone handle bracket mounted in rearward position for
increased seat depth.