User Manual

05
SPEX BACK SUPPORT USER MANUAL 7
WWW.SPEXSEATING.COM
Place the lower locating pins in the bottom hooks, and position
the Back Support in the upright position.
Loosen the upper Back Support bracket enough to be able to
slide it up or down, to locate the locking pin inside the quick
release catch.
Ensure the catches have engaged on the top connection pins.
7.
8.
Ensure the Back Support is aligned squarely, with even space
either side of the Back Support and canes.
Tighten the cane mount fasteners. Spex recommends 5 Nm of
torque.
9.
10.
11.
If further angle alignment is required, use the extension
bracket #1259-2450-100.
The quick release mechanism should be removed from
the clamping bracket, and reattached to the extension
bracket.
The bracket can then be reattached using the M6 x 12
fasteners and Slim T-Nuts included with the extension
bracket.
To release the Back Support, rst hold the top of the
Back Support, then lift the locking levers to disengage
the latch mechanism.
Lift the Back Support away from the wheelchair.
12.
13.
14.
Adjust the location of the pins to adjust the angle and seat
depth of the Back Support, and tighten once in correct position.
Spex recommends 5 Nm of torque.
Before use, always check that the quick release latches are prop-
erly engaged.
WARNING