Installation Guide

6 WWW.SPEXSEATING.COMSPEX HEAD SUPPORT USER MANUAL
Installing Mounting Block
4mm Hex Key
1.
Screw the mounting block directly to the back support
using the M6 x 25mm screws and washers. Use a 4mm hex
key to tighten the screws.
Attaching Stylo to Headrest
3mm Hex Key
1.
Screw the Stylo directly to the headrest using
the M5 x 10mm screws, then securely tighten
the screws using a 3mm hex key.
Attaching Ball to Mechanism
5mm Hex Key
1.
Loosen both bolts in the top clamp to allow the ball on the headrest
to insert into the socket.
2.
Partly tighten the bolts on the top clamp so the headrest can move
but is not loose.
3.
Position the headrest correctly, then securely tighten the bolts using
a 5mm hex key.
Inserting Stem
1.
To insert the stem into the mounting block, ensure the screw on the
ball is facing towards the back support.
A
DETAIL
A
SCALE
1 : 5
C O N F I D E N T I A L
THIS INFORMATION IS HIGHLY CONFIDENTIAL AND IS THE
EXCLUSIVE PROPERTY OF MEDIFAB LIMITED.
THIS DRAWING MUST NOT BE USED FOR ANY PURPOSE
OTHER THAN THAT EXPRESSLY PERMITTED BY THE OWNERS
AND MUST BE RETURNED TO MEDIFAB LIMITED.
B
DETAIL B
SCALE 1 : 1
B02
Head Support Mounting Ball Assy
A3
SHEET
1 OF 1
DWG NO.
DESCRIPTION:
REVISION:
MATERIAL:
NAME
DEBURR AND BREAK SHARP EDGES
FINISH:
APPV'D
CHK'D
DRAWN
SCALE:1:2
DATE
hugo.james - Thursday, 22 July 2021 1:09:00 pm -
WEIGHT:
UNLESS OTHERWISE SPECIFIED: DIMENSIONS ARE IN MILLIMETERS
LINEAR TOLERANCES: +
0.2mm
ANGULAR: TOLERANCES: + 0.5°
2148.25 g
32 Detroit Drive
Rolleston 7675
2
1
1
2
PART NO.
ERP NO.
A-04275
1274-4179-100
ECN
CHANGE
A-04275
New Zealand
Phone [phone]
A
DETAIL A
SCALE 1 : 1