Mini Extension Anemometer Probe 850073 Instruction Manual SPER SCIENTIFIC LTD.
TABLE OF CONTENTS I. INTRODUCTION ............................................................................. 2 II. PANEL DESCRIPTION ................................................................... 2 III. MEASUREMENT PROCEDURES .................................................. 3 IV. SPECIFICATIONS .......................................................................... 3 VII. WARRANTY.................................................................................... 4 I.
III. MEASUREMENT PROCEDURES • Plug probe into the PROBE INPUT SOCKET. • Make sure the PROBE LOCK is in the lock position • Turn on the instrument by pressing the POWER button. • Holding the TELESCOPING PROBE, aim the yellow point on the VANE PROBE HEAD toward the source to be measured. • Press the K/J (B) button to select the unit of measure: m/s, hm/h, ft/min, mile/h, or knots. Measurement results are shown on the upper display and the unit of measure on the bottom-left of the LCD.
ONE YEAR WARRANTY Sper Scientific warrants this product against defects in materials and workmanship for a period of one year from the date of purchase, and agrees to repair or replace any defective unit without charge. If your model has since been discontinued, an equivalent Sper Scientific product will be substituted if available. This warranty does not cover damage resulting from accident, misuse, or abuse of the product.
