Manual

- 10 -
7. BATTERY REPLACEMENT
When the left corner of the LCD displays the low battery icon install 4 new AA
1.5V batteries. Slide the BATTERY COVER (10) away from the instrument to
remove the old batteries. When the clock is not accurate, replace the 3V but-
ton cell battery located in the compartment behind the AA's. Re-attach the
battery cover when you have finished. In-spec measurements may be made
for several hours after the low battery indicator appears.
8. TROUBLESHOOTING
Gently insert a pin or small object into the SYSTEM RESET (14) while turning
on the meter.
9. OPTIONAL ACCESSORIES
840097 AC to DC 9V Adapter
840090 Water Resistant Instrument Pouch
840092 Bench-Top Tripod
840093 Field Tripod
840094 USB RS232 Serial Adapter
10. OFFSET (ZERO) PROCEDURE
With the SENSOR HEAD (18) completely dry, press the ▲ (5) button for at
least two seconds until the meter beeps and the display changes to zeros.
11. CONDUCTIVITY CALIBRATION
Although calibration is not generally needed, the following procedures should
be performed the first time a new probe is used, when the electrode is
changed, or after the meter has been in use for a long period of time.
D10
Polarity: 0 = Positive 1 = Negative
D11 & D12
Annunciator for Display
°
C = 01
°
F = 02 %RH = 04
D13
The upper display data = 1, The lower display data = 2
D14 4
D15 Start Word = 02
RS232 Com Port Settings: 9600, No parity, 8 Data bits, 1 Stop bit
D9 Decimal Point (DP), position from right to the left
0 = No DP, 1= 1 DP, 2 = 2 DP, 3 = 3 DP