Instruction Manual

26
Reference (Normalization)
Temperature (tnr)
After saving the temperature unit setting,
the pen will automatically enter the
reference temperature setup.
1. Press ▲ to select 20°C or 25°C.
2. Press SET for less than one second
to conrm the value or press SET for
more than 2 seconds to return to P1.0
without saving.
When meter is in measurement mode,
press " " more than 2 sec to enter
setup mode. Press " "or " " or
" " to select
momentarily again to enter unit setting.
Press " " or " " to select C /F.
Press " " momentarily to confirm the
unit or press " " more than 2 sec to
return to P1.0 without saving.
After confirming the unit, you can
continuously set another temp. related
parameters (except 8371) or press
" " more than 2 seconds to return
to P1.0.
While in P1.0, press " " for more
than 2 seconds to return to measure-
ment mode.
P1.0, then press " "
or
Short
press
Long
press
or
Long
press
P1.0: temperature parameter setting: (t)
To change the parameters, you can
press " " more than 2 sec. to enter
setup mode when the meter is in
measurement mode.
P1.1: Change temperature unit (tUt):
8