4 Channel Datalogging Thermometer 800024 800024 INSTRUCTION MANUAL T1-T2 SETUP 304 HOLD INTV CLOCK REC RANGE C 200 C 328 F POWER-UP OPTIONS REC SPER SCIENTIFIC LTD.
CONTENTS TITLE PAGE I. Introduction…………………………………………………………………………….…..1 II. Specifications…………………………………………………………………………… 1 III. Symbol Definition and Button Location……………………………….2 IV. Operation Instructions…………………………………………….……………… 3 4.1 Power-Up & turn ON/OFF backlight………………………………………………….....3 4.2 Connection the Thermocouples………………………………………………………....3 4.3 Selecting the Temperature Scale……………………………………………………….. 3 4.4 Data-Hold Operation…………………………………………………………………….… 3 4.
I. Introduction: This instrument is a four channel digital thermometer for use with any K-type thermocouple as temperature sensor. Temperature indication follows National Bureau of Standards and IEC584 temperature/voltage table for K-type thermocouples. It internal memory can keep up to 16,000 records per channel. (note1.) It uses RS232 interface to perform bi-directional communication with PC. II. Specifications: Numerical Display: 4 digital Liquid Crystal Display per channel.
III. Symbol Definition and Button Location: : This indicates that the minus temperature is sensed. : Centigrade and Fahrenheit indication. : Thermocouple Type Indication. : The Maximum value is now being displayed. : The Minimum value is now being displayed. : This indicates auto power off is enabled. : This indicates that the display data is being held. : The Battery is not sufficient for proper operation. : It indicates the value below is T1, T2, T3, T4 Temperature sensor.
IV. Operation Instructions: 4.1 Power-Up & Turn ON/OFF backlight The •I key turns the Thermometer ON or OFF and backlight ON & OFF. Press it once to turn on the Thermometer. Press it again for moment to turn ON or OFF backlight. Press and hold this button 3 second to turn OFF the power. 4.2 Connection the Thermocouples For measurement, plug the thermocouple into the input connectors. 4.
3: press "REC" • or "°C/°F" • to increase or decrease number, press “MAXMIN " (INTV) to adjust next item, then press “MAXMIN” (INTV) to finish. If you want abort during a setup process, press power button to cancel. 4.9 MAX/MIN Operation: When pressing the "MAX MIN" button the meter will enter the MAX/MIN mode. Under this mode the maximum value, minimum value is kept in the memory simultaneously and updated with every new sample of data. When the MAX symbol is display, the Maximum is shown on the display.
RAM ; At least 5 MB byte hard disk space available to install TestLink. Recommended resolution 800X600. Install TestLink: 1.We recommend close all other application before installing TestLink. 2.Insert setup CD disk to CD disk drive. 3.Choose the Start button on the Taskbar and select Run. 4.Type E:\SETUP and choose OK, then it will copy SE309.exe ( executable file ) and help file to your hard disk ( default is c:\program files\TestLink\SE309 ).
