User Manual

1188
IIXX.. TTrroouubblleesshhoooottiinngg GGuuiiddee
(cont.)
PPRROOBBLLEEMM PPoossssiibbllee CCaauussee CCoorrrreeccttiivvee AAccttiioonn
IInnddiiccaattiioonn:: mmeecchhaanniiccaall ffaauulltt ( ( c c o o n n t t . . ) )
• Packing box(es) too tight, too loose, wrong Adjust, relubricate or replace packing; align box(es).
packing, packing dried or worn out, out of
alignment.
• Mechanical seals misaligned, broken or Realign or replace seals or parts.
worn out.
• Solids or liquids passing through machine. Disassemble, inspect and clean machine; install inlet
filter to prevent further contamination.
• Soft foot on motor or blower. See page 5.
• Machine in surge (see page 8). Increase airflow.
• Stacked impeller hub nuts too tight. Loosen hub nuts 1/2 turn.
• Belts on belt drive machine loose, slapping. Tighten belts to proper tension.
• Harmonic pulsation from gasoline Change engine speed to remove pulsation.
engine driver.
• Machine not on solid foundation. Reinforce foundation.
MMOOTTOORR HHOOTT ((CChheecckk wwiitthh ssuurrffaaccee tthheerrmmoommeetteerr;; ccoonnssuulltt SSppeenncceerr SSeerrvviiccee DDeeppaarrttmmeenntt ffoorr aassssiissttaannccee))
• Am
bient temperature too high for insu- Cool motor or replace with motor having proper insulation.
lation class.
• Incorrect voltage. Change to correct voltage.
• Incorrect cycle. Change to correct cycle.
• Electrical short-circuit insulation failure. Repair or replace motor.
• Motor overloaded, too much air Check for system leaks, throttle back butterfly valve,
passing through blower. install larger motor.
• Unbalanced voltage supply (gas boosters Check power company for correction.
only).
MMAACCHHIINNEE
VVIIBBRRAATTIINNGG