Instruction Manual

EN
6
Bind Button
BINDING AND CALIBRATING
Binding is the process of linking the SR6100AT receiver to your Spektrum
transmitter. The AVC features on the receiver can be enabled or disabled during
the binding process. There is no bind plug on the SR6100AT, a button is used
to put the receiver in bind mode.
IMPORTANT: You must calibrate the SR6100AT receiver each time it is placed
in bind mode, regardless of AVC being enabled or disabled.
TELEMETRY
In addition to SMART Throttle, the SR6100AT Telemetry Receiver features two integrated
telemetry ports that are compatible with telemetry capable DSMR transmitters.
The Telemetry ports include:
• Voltage (0V – 51V)
• XBus Port
VOLTAGE SENSOR
• Plug the voltage sensor
(SPMA9570) into the VOLT
port on the SR6100AT.
• To connect the voltage
sensor to your vehicle, typically it would be soldered to the battery
connector. Attach the stripped end of the voltage sensor wires to the
positive (red) and negative (black) wires of the voltage source, matching
red to red and black to black.
Voltage Port
XBus Port