System Manual

SERVO TRAVEL
The servo travel on the Steering and Throttle channels can be adjusted through a special programming mode in the transmitter.
1. Begin with the transmitter binding process to the receiver complete. Power ON the receiver.
2. Hold full right and full brake while powering the transmitter ON to put the transmitter into programming mode.
The LED on the transmitter will flash 4 times to indicate it is in programming mode.
3. Turn and hold the wheel full left to set the travel limit for that direction, Press the A button to increase travel, press the B
button to reduce travel. The LED will flash once with every change. Return the wheel to center to set the travel value.
IMPORTANT: If the value has reached the maximum or minimum that can be accepted, the LED will not flash with further input.
4. Turn the wheel to the right and repeat the process to set the steering travel to the right.
5. For electric vehicles, power the Transmitter OFF to save the settings. Calibrate your ESC to the default throttle travel.
6. For fuel powered vehicles, set the throttle travel without the engine running; After setting steering travel, you can set
throttle travel with the same process. Pull and hold full throttle, adjust travel with the A and B buttons, return to center to
set the value.
7. Push full brake, adjust travel with the A and B buttons, return to center
8. Power the transmitter OFF to save the values.
FACTORY RESET
There is a hidden mode if you want to reset the servo travel and calibration in the transmitter.
1. Hold full left and full brake while powering the transmitter ON to put the transmitter into programming mode.
The LED will flash 4 times then turns OFF to indicate factory reset.
2. Release the wheel and throttle trigger back to neutral and the LED will illuminate to indicate factory reset is complete.
3. Power the transmitter OFF.
3SPEKTRUM SLT3 USER GUIDE
EN
SPMSLR300 3 CHANNEL RECEIVER
Specifications
Type: FHSS 2.4GHz SLT Protocol
Dimensions (LxWxH): 33.4mm x 21mm x 12.6mm)
Antenna Length: 140mm
Channels: 3
Weight: 6 grams
Band: 2.4GHz
Voltage Range: 3.5–9.6V
Bind Type: Bind Plug
LED
BIND/ Battery port
Steering Channel
Throttle Channel
Auxiliary Channel
SLR300 BINDING
1. Insert the bind plug into the bind port on receiver.
2. Power on the receiver, the LED will flash rapidly to indicate it is in bind mode.
3. Power on the transmitter; the LED light on the receiver will stop flashing an stay illuminated to indicate binding is
complete.
FAILSAFE
Always set the failsafe position for zero throttle.
1. Power on the TX and RX ,make sure the transmitter and receiver are connected properly.
2. Hold steering, throttle trigger and AUX controls at the desired failsafe positions.
3. Insert the bind plug into the bind port on the receiver; The LED on the receiver will flash 3 times and then remain lit to
indicate the failsafe positions have been set.
SLR300 LED INDICATOR
• When the receiver enters bind mode, the LED flashes rapidly.
• If the receiver looses signal, the LED light flashes slowly to indicate it is in failsafe mode.
• When the receiver is connected to the transmitter, the LED remains illuminated.
• When setting the fail-safe positions, the LED light flashes three times and then remains illuminated.