System Manual

EN
9
Operation
Pre ight Checklist
❏ Inspect the model, wiring, and electrical components.
❏ Activate Normal Flight Mode on the transmitter.
❏ Activate Throttle Hold on the transmitter. Lower the throttle to stop or
idle.
❏ Power ON the transmitter.
❏ Power ON the model, and wait for initialization to complete.
❏ Complete the tailrotor and cyclic tests.
❏ Connect the  ight pack to the ESC (electric models).
❏ Verify that all connected remote receivers display a solid orange LED.
❏ Con rm that the transmitter roll, pitch, yaw and collective inputs cor-
respond to the helicopter controls.
❏ Con rm that the FC6250HX is compensating in the correct direction.
❏ Review all operational instructions before  ying your model.
❏ Place the model on a level surface for take off.
Post ight Checklist
❏ Disconnect the  ight battery (electric models)
❏ Power down the FC6250HX
❏ Always turn the transmitter off last