Quick Start Guide

2904 Research Rd • Champaign, IL • 61822 • 800.338.4639• horizonhobby.com

FC6250HX PC Programmer Beta V1

Quick Start Guide October 8, 2021

Connecting the FC6250HX and Application Usage;

Always remove the pinion gear or disconnect the drive motor(s) from the ESC to disengage the

drive system before connecting your FC6250HX to the settings application. The main rotor

blades may turn in response to transmitter settings or transmitter inputs. Failure to do so could

result in serious personal injury or property damage.

Once the fc6250hx has been connected the pc application will automatically connect and you

should see [Not Connected] change to [Connected] with an orange background.

All parameters changed will trigger a delayed update ([Update Settings] button changes to

orange), this allows you to change multiple parameters before the update automatically occurs.

Do not disconnect the cable from the fc6250hx when the [Update Settings] button is orange as

an update is pending.

Flight Control shows the main flight settings used, for example common adjustments for swash

and tail gains and SAFE gains / attitude settings. Only intended for quick adjustments. The

[Setup] tab is where system setup and not frequently used settings are handled. All settings are

available to open stick firmware and BNF/RTF firmware will disable some of the settings to

avoid incorrect settings of known values.

Settings can be saved to and loaded from your local drive to transfer setups between models.

You can also load parameters from your local storage, edit and save back to storage as well.