Quick Start Guide

2904 Research Rd • Champaign, IL • 61822 • 800.338.4639• horizonhobby.com

FC6250HX PC Programmer Beta V1

Quick Start Guide October 8, 2021

Warnings

Always remove the pinion gear or disconnect the drive motor(s) from the ESC to disengage the

drive system before connecting your FC6250HX to the PC settings application. The main rotor

blades may turn in response to transmitter settings or transmitter inputs. Failure to do so could

result in serious personal injury or property damage.

The settings application is simply an interface to the FC6250HX internal parameters, the

settings application does not disable the drive motor(s), ESC, or throttle servo once connected

to the settings application. Always disable the drive system on your model before connecting to

the settings application.

Before every flight perform a pre-flight check to ensure your model is ready for flight and verify

that the flight controller settings are correct.

Always follow the Setup Instructions within the product manual for initial setup. The settings

application is only intended for adjusting settings, backing up and restoring model settings.

Requirements

a. FC6250HX v5.5 Firmware or later (open stock or RTF/BNF)

b. SPMA3065 USB Programming Cable

c. OS: Windows 7 SP3, Windows 8, Windows 8.1, Windows 10 or Windows 11. Admin

rights required to install the USB cable driver.

Installation

1 Download the 6250HX PC Programmer HERE

2 Right click in file explorer and select Install from the pull-down menu

3 Follow the prompts to allow the installation

PAGE 1
FC6250HX PC Programmer Beta V1 Quick Start Guide October 8, 2021 Warnings Always remove the pinion gear or disconnect the drive motor(s) from the ESC to disengage the drive system before connecting your FC6250HX to the PC settings application. The main rotor blades may turn in response to transmitter settings or transmitter inputs. Failure to do so could result in serious personal injury or property damage.
PAGE 2
FC6250HX PC Programmer Beta V1 Quick Start Guide October 8, 2021 Running the PC Application 1. Connect the SPMA3065 USB Programming Cable 2. Click the FC6250HX desktop icon creating during installation 3. If the application mentions you need to install the USB cable driver follow the prompts and instructions provided. 4. If using a remote receiver in the data/bind/rx2 port you will need to disconnect this before connecting the SPMA3065. 5.
PAGE 3
FC6250HX PC Programmer Beta V1 Quick Start Guide October 8, 2021 Connecting the FC6250HX and Application Usage; Always remove the pinion gear or disconnect the drive motor(s) from the ESC to disengage the drive system before connecting your FC6250HX to the settings application. The main rotor blades may turn in response to transmitter settings or transmitter inputs. Failure to do so could result in serious personal injury or property damage.