Spektrum AR630 AS3X and SAFE 6 CH Receiver Spektrum AR630 AS3X und SAFE Empfänger mit 6 Kanälen Récepteur 6 canaux SAFE et Spektrum AR630 AS3X Ricevitore Spektrum AR630 AS3X e SAFE 6 CH
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit horizonhobby.com or towerhobbies.com and click on the support or resources tab for this product.
EN AR630 AS3X and SAFE Telemetry Receiver The Spektrum™ AR630 Receiver is full range with telemetry, and is compatible with all Spektrum™ DSM2® and DSMX® technology transmitters. Perform the setup for the AR630v receiver through a compatible Spektrum Transmitter with Forward Programming. The Spektrum PC Programmer can be used for firmware updates. Table of Contents Smart Throttle...............................................................................................4 Specifications.................
EN Specifications Type Application Channels Receivers Modulation Telemetry Bind Method Failsafe Band Dimensions (LxWxH) Weight Input Voltage Resolution Antenna Length AR630 DSM2/DSMX 6 CH AS3X Telemetry Receiver Air 6 1 DSM2/DSMX Integrated Bind Button, Bind Plug Yes 2.4GHz 1.85 x 0.95 x 0.51inches (47 x 25 x 13mm) 0.34oz (9.5g) 3.
EN Telemetry The AR630 features short range telemetry and will provide receiver battery voltage, and flight log data, plus Smart ESC telemetry when available. The AR630 is not compatible with the Spektrum telemetry sensors See www.spektrumrc.com for more information about Spektrum Telemetry systems. Installing the AR630 Receiver 1. Mount the receiver using double-sided servo tape.
EN Transmitter and Receiver Binding Programming the AR630 receiver requires a Spektrum™ DSM2®/DSMX® compatible transmitter with Forward Programming. Binding The AR630 receiver must be bound to your transmitter before it will operate. Binding is the process of teaching the receiver the specific code of the transmitter so it will only connect to that specific transmitter. 1. Push and hold the bind button on the receiver while turning the receiver on.
EN Testing Failsafe Secure the aircraft on the ground and remove the propeller. Test Failsafe settings by turning the transmitter RF output off and noting how the receiver drives the control surfaces. Receiver Power Only • The servo ports will not have a control signal if the receiver is turned on when no transmitter signal is present. • All channels have no output until the receiver has linked to the transmitter. Initial Setup 1.
EN AR630 Receiver- Basic AS3X Setup To use AS3X technology with the Spektrum AR630 Receiver, the receiver needs to be set up with a compatible Spektrum transmitter. 1. Verify the basic setup and trim is accurate before attempting AS3X setup. 2. Forward Programming Setup: The receiver is directly configured through the Forward Programming menu. 1. Low throttle is required to enter Forward Programming, we recommend enabling throttle cut and verify it prevents motor operation.
EN AS3X Reaction Test This test ensures that the AS3X control system is functioning properly. 1. Assemble the aircraft, bind your transmitter to the receiver, and complete the AS3X First Time Setup in the Forward Programming menu before performing this test. 2. Raise the throttle above 25% to activate AS3X, then lower the throttle. Once the AS3X system is active, control surfaces move in respose to aircraft movement. AS3X remains active until the battery is disconnected.
EN AR630 Receiver- SAFE Setup Setting up SAFE Technology on the AR630 Receiver takes place in Forward Programming. 1. Complete the AS3X setup and verify operation in flight. 2. Forward Programming Setup: To add SAFE flight stabilization the Flight Modes on the receiver need to be configured. 1. In your transmitter’s menu select Forward Programming -> Gyro Settings -> First Time SAFE Setup IMPORTANT: Before proceeding with setup, read every information screen that will appear on your transmitter screen.
EN Advanced Tuning Basic gain tuning can be as simple as using a slider, but to fine tune the AS3X system there are many setup and tuning options. AS3X Gain tuning options 1. In your transmitter’s menu select Forward Programming -> Gyro Settings -> AS3X Settings • AS3X Gains can be changed for each axis, you can increase the gain values for roll, pitch and yaw separately to maximize the performance without oscillation. We recommend making small changes on one axis at a time.
EN 2. When you add Flight Modes within Forward Programming, additional tuning options are added in the AS3X Setting menu. Be sure to change through all the flight modes with your assigned switch and verify values for each feature for every flight mode. Select Forward Programming -> Gyro Settings -> AS3X Settings • AS3X Gains can be adjusted for each axis and each mode. Change the flight mode switch position when this option is selected and a separate screen will appear for AS3X gains on each flight mode.
EN SAFE Setting menu. The First Time SAFE Setup should be sufficient to fly your airplane, but to fine tune the SAFE system there are many setup and tuning options. Select Forward Programming -> Gyro Settings -> SAFE Settings -> • SAFE Gains can be fine tuned for each axis within each Flight Mode. • Angle Limits can be changed for each flight mode • Fixed/ Adjustable Gain operates the same as this feature in AS3X, but applies to SAFE gain.
EN Other Settings (Forward Programming) System Setup Select Forward Programming -> Other Settings -> • Select Failsafe -> Select each channel and assign it to Preset or Hold Last. When you select a different channel for Output, a new group of settings appears. Capture Failsafe Positions -> Hold the control sticks in the desired failsafe positions and select Apply. Channel selections must be individually set in Forward Programming to apply the preset positions or each channel will default to Hold Last.
EN Differences between Self Leveling/Angle Demand and AS3X modes This section is generally accurate but does not take into account flight speed, battery charge status, and other limiting factors.
EN Flight Log Flight Log data can help you optimize the control link for your aircraft. Flight Log data is displayed on telemetry capable Spektrum transmitters. Using the Flight Log A - Fades on main receiver B - Fades on remote receiver L - Not available on AR630 R - Not available on AR630 F - Frame losses H - Holds Fades Represents the loss of one bit of information on one receiver. Fades are used to evaluate the performance of each individual receiver.
EN Range Testing Before each flying session, and especially with a new model, it’s important to perform a range check. All Spektrum aircraft transmitters incorporate a range testing system, which reduces the output power to allow a range check. 1. With the model resting on the ground, stand approximately 100 feet (30 meters) away from the model. 2. Face the model with the transmitter in your normal flying position and put your transmitter into range test mode. 3.
EN Receiver Power System Requirements Some of the power system components that affect the power supply to the receiver include: • Receiver battery pack (number of cells, capacity, cell type, state of charge). • The ESC’s capability to deliver adequate voltage to the receiver when the servos demand high current • The switch harness, battery leads, servo leads, regulators etc. The AR630 has a minimum operational voltage of 3.
EN Heading- An optional feature of AS3X, heading will make the airplane try to hold its attitude when the control is relaxed. This is not a self-leveling feature, it only makes the aircraft track accurately. Gain- Tells the stabilization system the level of damping it should provide. SRXL2- A Bi-Directional data communication protocol that enables digital devices to communicate over a single signal wire. Forward Programming- Programming directly on the receiver from the transmitter.
EN Troubleshooting Guide AS3X Problem Possible Cause Solution Damaged propeller or spinner Imbalanced propellereller Replace propellereller or spinner Motor vibration Loose receiver Oscillation Loose aircraft controls Worn parts Irregular servo movement Gain too high Travel or Rates reduced causing reduced servo resolution Trim changes after initial setup 20 Inconsistent flight performance Changes to SubTrim after initial setup Incorrect response to the AS3X Control Direction Test Aircraft was n
EN Troubleshooting Guide Problem Aircraft will not respond to throttle but responds to other controls Possible Cause Solution Throttle not at idle and/or throttle trim too high Throttle servo travel is lower than 100% Reset controls with throttle stick and throttle trim at lowest setting Make sure throttle servo travel is 100% or greater (With battery disconnected from aircraft) Reverse throttle channel on transmitter Make sure motor is connected to the ESC Move powered transmitter a few feet from air
EN Problem Aircraft will not connect (after binding) to transmitter Control surface does not move 22 Possible Cause Solution Transmitter too near aircraft during connecting process Move powered transmitter a few feet from aircraft, disconnect and reconnect flight battery to aircraft Aircraft or transmitter is too close to large metal object, wireless source or another transmitter Move aircraft and transmitter to another location and attempt connecting again Bind plug left installed in bind port R
EN 1-YEAR LIMITED WARRANTY What this Warranty Covers - Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship for a period of 1 year from the date of purchase.
EN https://www.horizonhobby.com/content/service-center-render-service-center or call the toll free telephone number referenced in the Warranty and Service Contact Information section to speak with a Product Support representative.
EN Warranty and Service Contact Information Country of Purchase United States of America EU Horizon Hobby Horizon Service Center (Repairs and Repair Requests) Contact Information servicecenter.horizonhobby.com/ RequestForm/ Horizon Product productsupport@horizonhobby.com. Support (Product Technical 877-504-0233 Assistance) websales@horizonhobby.com Sales 800-338-4639 Horizon Technischer service@horizonhobby.eu Service Sales: Horizon Hobby GmbH Address +49 (0) 4121 2655 100 2904 Research Rd.
EN When operating your Spektrum receiver, please be sure to maintain a separation distance of at least 20 cm between your body (excluding fingers, hands, wrists, ankles and feet) and the antenna to meet RF exposure safety requirements as determined by FCC regulations. Supplier’s Declaration of Conformity Spektrum AR630 AS3X and SAFE 6 CH Receiver SPMAR630 This device complies with part 15 of the FCC Rules.
EN IC Information IC: 6157A-SPMAR630 CAN ICES-3 (B)/NMB-3(B) This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, Including interference that may cause undesired operation of the device. Cetappareilestconforme à la norme RSS d'Industrie Canada.
© 2020 Horizon Hobby, LLC. DSM, DSM2, DSMX, SAFE, AS3X, Spektrum Airware, SRXL2, SmartSafe, Hangar 9 and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. JR is a registered trademark of JR Americas. All other trademarks, service marks and logos are property of their respective owners. US 7,391,320. US 9,056,667. US 9,753,457. US 9,930,567. US 10,078,329. US 10,419,970.
