User Manual

15
SPEKTRUM DX5 PRO • TRANSMITTER INSTRUCTION MANUAL
EN
FUNCTION LIST
Automatic Braking System (ABS)
Idle Up
ABS helps prevent brake lock-ups and improves braking perfor-
mance by pulsing the brakes. ABS helps prevent brake lock-ups
and improves braking performance by pulsing the brakes.
Options:
• Point: The throttle position that the pulse braking takes place
(0 to 100, default is 50).
• Stroke: The distance the throttle travels during the pulse
braking (0 to 100, default is 50).
• Lag: The time delay before the pulsing takes place (0.0 to
2.0 in .01 increments, default is 0.0).
• Speed: The pulsing speed or frequency of the pulse braking
(-1 to -30, default is -10).
To activate ABS:
1. Assign a switch to toggle ABS ON/
OFF or select ON.
2. Select functions to edit.
3. The bar at the bottom of the screen
displays the parameters and shows
how ABS will function.
Deactivating ABS
• Assign switch to INH.
Idle up (also called high idle) is used to advance the throttle
position on a gas car during startup to prevent the engine from
dying before the engine is warmed up.
Options:
• Position: Adjusts the throttle position when idle up is
engaged (0 to 100, default is 0)
• Warning: Activates an alarm when the Idle Up is active
To activate Idle Up:
1. Assign a switch to toggle Idle Up ON/
OFF.
2. Select functions to edit.
3. The bar at the bottom of the screen
displays the parameters and shows how
Idle Up will function.
Deactivating Idle Up
• Assign switch to INH.
Traction
Traction Control helps reduce wheel slippage and improve
acceleration by gradually increasing the throttle.
Options:
• Point: The throttle position that traction control disengages
(5 to 100, default is 50).
• Speed: The time after pulling the trigger traction control
engages (1 to 100, default is 10).
To activate Traction:
• Assign a switch to toggle Traction ON/
OFF.
• Select functions to edit.
• Select the On The Fly (OTF) switch to edit
settings with out going into the Traction menu.
• The bar at the bottom of the screen
displays the parameters and shows how
Traction will function.
Deactivating Traction:
• Assign switch to INH.
Trim setup
Trim Setup affects the amount the servo travels with each click
of the trim, but has no effect on the total trim travel. The trim
steps range from 1 to 20 (Default is 9).
To adjust the trim steps:
1. Select channels to edit.
2. Scroll Up or Down to adjust the step
value.
3. Click the scroll wheel to save the
selection.