User Manual

SPEKTRUM DX5 PRO • TRANSMITTER INSTRUCTION MANUAL

PHYSICAL TRANSMITTER ADJUSTMENTS

• Turn off the DX5 Pro

• Using a 2mm hex wrench, remove 3 screws.

• Rotate the drop down to the desired angle.

• Align with the screw holes and re-install the 3 screws

being careful not to pinch any wires.

• Using a 2mm hex wrench, remove the 3 screws from the

drop down and remove the drop down from the transmitter.

Carefully disconnect the 2 wiring harness from inside the

transmitter.

• Using a 1.5mm hex wrench, remove the

steering wheel.

• Using a 2mm hex wrench, remove 2 screws

from the steering mechanism. Remove the

steering mechanism from the drop down

being careful to pull the wiring harness

through the opening.

• Keep the drop down in a safe place for future

use.

• Connect the 2 wiring harnesses to the board

inside the DX5 Pro. Note that one connector

has 6 pins and the other has 7.

• Re-install the steering mechanism directly onto the

transmitter using the 2 screws.

• Re-install the steering wheel.

• Refer to the Drop down steering wheel options section

above for directions on removing and installing the steering

mechanism.

• The wedge goes between the steering mechanism and

the drop down (or transmitter if the drop down is not being

used) and can be rotated to almost any angle.

• Wedges are two parts so wiring does not have to be

removed for changes.

Rotate:

Dropdown steering wheel options

The DX5 Pro comes with the dropdown wheel installed. The

dropdown can be rotated for a perfect feel or removed for a

standard wheel layout. All the parts necessary to convert to the

standard wheel are included.

Standard wheel conversion:

Steering Wheel Wedges

Wiring not shown

CAM

15º

10º

57840 SPM DX5 Pro DSMR Tx Manual_BOOK 2457840 SPM DX5 Pro DSMR Tx Manual_BOOK 24 4/26/18 2:56 PM4/26/18 2:56 PM