User manual

54 SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL
EN
PHYSICAL TRANSMITTER ADJUSTMENTS
Tension Set
Screw
Ratchet Set
Screw
Transmitter Mode Conversion
You can change to transmitter modes 1, 2, 3 or 4. This conversion
requires both a programming and a mechanical change.
The conversion consists of the following steps:
Programming Conversion
Change the Throttle Ratchet
Adjust the Elevator Centering Screw
Move the Throttle Limit Screws
Programming Conversion
1. Access the System Settings menu from the Setup List
and select the desired Mode. If you are changing between
Modes2and4or1and3,youcanSTOPafterStep1.
2.ExittheSystemSettingsmenutosavetheselection.
Changing the Throttle Ratchet
3. Locate the Throttle Strap adjustment screws on both gimbals.
The ratchet set screw engages a serrated section on the
gimbal for a ratcheted throttle, while the tension set screw
engages a strap for smooth tension on the gimbal.
4. To engage the throttle ratchet turn the ratchet set screw
clockwise until the ratchet engages.
5.Todisengagethethrottleratchetturnthescrewcounter
clockwise until the gimbal moves freely.
If you only need to adjust the throttle friction, see the Throttle
Strap Adjustment section.
Adjusting the Gimbal Centering Screw
When changing between Modes 1 and 2, or between Modes 3
and 4, you must adjust the gimbal centering screw.
1.UseaPhillipsscrewdrivertotightenthegimbalcenteringscrew.
Tightening the screw will disengage the centering spring.
2.UsingaPhillipsscrewdriver,loosentheoppositegimbal
centering screw until the lever engages.
Throttle limiting screws
Throttle limiting is used on the throttle gimbal to limit the
maximumtravel.WhenchangingbetweenModes1and2,or
between Modes 3 and 4, you can limit the throttle gimbal.
1. To disengage the throttle limiting, turn both of the limit screws
one half turn and slide them both to the opposite side of the
track.
2. To engage the throttle limiting, turn both of the limit screws one
half turn and slide them both to the opposite side of the track.
Calibration
Poweronthetransmitter.Whenacalibrationscreenshows,
movethecontrolstickstoextremesandtocentersasdirectedto
correctly calibrate controls.
Move the gimbals in + sign movements lightly touching the end
points to properly calibrate the gimbals.
Elevator
Centering Screw
Throttle Limit
Screws
The DX20 has all the physical transmitter adjustments located
around the gimbal face of each gimbal. This arrangement allows
for quick and easy adjustments with out taking the back cover off
or removing any plugs to access adjustment screws or wedges.
Available adjustments:
Mode Change
Change the Throttle Ratchet
Change the Throttle Tension
Adjust stick tension