User manual

46 SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL
EN
ACRO (AIRPLANE)
Acro Gyro Function
The Gyro menu option enables you to create up to 7 gyro gain
pointsonamaximumof4curves.Gyrogaincurvesalsoprovide
exibilityinreducinggyrogainasthecontrolstickmovesfarther
away from the center.
To access the Gyro screen
1. In the System Setup List, highlight Aircraft Type.
2. In the Aircraft Type Screen, select NEXT at the bottom right of
the screen. This will access the Aircraft Options screen.
ActivatethedesiredGyrofunction(s).Whenthegyrofunctionis
active, the Gyro function appears in the Function List.
To program a Gyro curve:
1. Access the Gyro 1, Gyro 2 or Gyro 3 menu option from the
Function list.
2. Assign either Aircraft or Heli to the Gyro Type.
3. Select a trim or pot to use for a gyro gain trim if desired. Op-
tions available include: R. Knob, L Lever, R Lever, L TrimA, and
R TrimA.
4. Scroll to Inh > Inh.
a. Select the first Inh and assign the input channel for the Gyro.
Forexample,ifthegyroisinstalledtoassistontheailerons,
select Ail.
b. Select the second Inh and assign the output channel for the
Gyro,forexample,theGearchannel.
5.SelecttheCurveyouwishtoedit.
6. Add the desired gyro gain values to the points on the curve.
7. Assign the switch positions to activate the gyro curve. The
curveisactivewhentheboxissolid.
Pitch Curve Function
InAcromodeaPitchCurvescreenisavailablethatallowsa
variable pitch propeller to be used. Up to 4 programmable curves
are available that can be selected via a switch, knob or stick
position. Up to 7 points can be programmed at the desired position
oneachcurve.NotethatthePitchcurveisdrivenbythethrottle
stick position.
To access the Pitch Curve screen:
1. In the System Setup List, highlight Aircraft Type.
2. In the Aircraft Type Screen, select NEXT at the bottom right
of the screen. This will access the Aircraft Options screen. Acti-
vatethePitchCurvefunction.WhenthePitchCurvefunction
isactivated,thePitchCurvefunctionappearsintheFunction
List.
3. Assign the pitch channel in the Channel Assignment function
afteractivatingthePitchCurveFunction.