User manual

43SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL
EN
Use System Setup to enter the System List from the Function list
without turning the transmitter off. A Caution screen will appear
thatwarnsthatRFwillbedisabled(thetransmitterwillnolonger
transmit).PressYES if you are sure and want to access the System
List. If you are not sure, press NOtoexittothemainscreenand
continue operation.
If you do not press YES or NO,thesystemwillexittothemain
screenandcontinueoperationwithinapproximately10seconds.
WARNING: Do not press YES unless the model is turned
off or the model is secured.
The Monitor screen displays the servo positions for each channel
graphically and numerically. This is useful to verify programming
functions,trimsettings,mixdirections,etc.Thenumericvalueis
directlyrelativetothetraveladjustandmixvalues(e.g.,100%
traveladjustequals100%valueintheMonitor).
ThenumberofchannelsdisplayedcanbeeditedbygoingtoExtra
Settings in the System Settings menu.
See the “Channel Monitor” section on page 31 for more
information.
FUNCTION LIST
System Setup
Monitor
X-Plus Monitor
UseoftheX-PlusMonitorrequiresX-Plustobeactive.TheX-Plus
MonitorscreendisplaystheoutputpositionforeachX-Pluschan-
nel graphically and numerically. This is useful to verify program-
mingfunctions,trimsettings,mixdirections,etc.Thenumeric
valueisdirectlyrelativetothetraveladjustandmixvalues(e.g.,
100%traveladjustequals100%valueintheX-PlusMonitor).The
X-PlusMonitorshowstheadditionalchannelsandrequiresservos
whichcanbeconnectedtotheoptionalX-Plusmoduleandan
X-Plus-capablereceiver.
CAUTION: Do NOT connect throttle or any primary
controlsurfacetotheX-PlusModule.