User manual

39SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL
EN
CombinationMixingisavailabletocreateAND/ORmixing.OR
mixingallowsyoutoassign2conditionswherethemixwill
activateifeitherconditionoccurs.YoucanalsocreateANDmixing
where2conditionsmustoccurtoactivatethemix.
To program Combination Mixing:
1.Activateamix.
2. Select Combo Sw. in the Switch Selection. The Combo screen
appears.
3. Select the desired switch and active switch position for Switch
1.ThemixisActivewhentheswitchpositionboxislled.
4.SelecttheRelation(AND,OR)
5.SelectthedesiredswitchandactiveswitchpositionforSwitch
2.ThemixisActivewhentheswitchpositionboxislled.
6.PresstheBACKbuttontosavetheCombinationMix.
TheMaster(leftside)namesareinputs.Forexample,“Aileron”
referstotheAileronStick.TheSlave(rightside)nameisthename
ofthechannelreceivingthemixcommandwhentheMaster
channel moves.
BackMixingappliestoallrelatedservosinamultiservoAileron/
Flappedwingoramultiservosplitelevator.CreatingamixtoRAL
(RightAileron)orLAL(LeftAileron)willcreatedifferentresultsand
enablesyoutousefewermixestoachievethedesiredresponse.
Example1:CreatingamixAIL>RALwillmovetheaileronsin
oppositedirections,whilecreatingamixAIL>LALwillmovethe
ailerons in the same direction.
Example2:CreateamixELE>RELwillmovetheelevatorhalves
together,whilemixingELE>LELwillmovetheelevatorhalvesin
theoppositedirection(tailerons).
IMPORTANT: Be sure the right aileron is connected into the AIL
portonthereceiverandtheleftAileronisconnectedintotheAux1
port on the receiver.
Whenadjustingthemixvaluesnearcenter(below10),1/2%mix
values are available for fine adjustment capability.
IMPORTANT:Thisfunctionisonlyavailableinprogrammixesand
rudder to aileron/elevator in aircraft model type.
OriginMixingusestruestickpositionastheinputforamix.When
originmixingisselected,anyothersettingstothemasterchannel
willbeignoredandthemixwillbebasedstrictlyonstickposition
and trim position. When Aileron, Elevator, or Rudder are selected
asthemaster,originmixingisavailable.OnceAileron,Elevator,or
Rudderareselected,anNwillappearnexttothemasterchannel,
where N means normal. Roll and select the N to change to O for
originmixing.Next,selecttheslavechannelandsettheswitchand
mixratesasdesired.
FUNCTION LIST

Back Mixing

1/2 Mixing Values

Origin Mixing

Combo Mixing