User manual

38 SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL
EN
Mixingallowscontrolinputforachanneltoaffectmorethanone
channelatatime.Mixingfunctionssupport:
• Mixingachanneltoanotherchannel.
• Mixingachanneltoitself.
• Assigningoffsettoachannel.
• Linkingprimarytosecondarytrim.
These mixes are available for each model memory:
Select a channel for master and slave. Inputs for the
master channel control both the master and slave channels. For
example,ElevatortoFlapmakeselevatorthemasterchanneland
flap the slave channel.
• 16programmablemixes
• CyclictoThrottle(HELI)
• Swashplate(HELI)
• ElevatortoFlap(ACRO)
• AilerontoRudder(ACRO)
• Rudder to Aileron/Elevator
(ACRO).
• Aileron>Rudder(SAIL)
• Aileron>Flap(SAIL)
• Elevator>Flap(SAIL)
• Flap>Elevator(SAIL)
If you wish to assign a mix to a switch position:
1.Makesureyouareinthedesiredmixscreen.
2.Movetheswitchyouwanttoassignthemixto.
3.Scrolltotheswitchpositionwhereyouwantthemixtobe
active.
4.Pressthescrollwheeltoactivatethemix.Whentheboxis
lled,themixisactive.
ThemixisActivewhentheboxislledandInactivewhenthe
boxisopen.Youcanassignamixtobeactiveinmultipleswitch
positions(0,1or2).
CAUTION: Always do a Control Test of your model after
changingmixes.
FUNCTION LIST
Mixing

Assigning a Mix to a Switch

Offset

Trim
Change the Offset value to move the effective center position
oftheslavechannel.Positiveornegativevaluedeterminesthe
directionoftheoffset.Offsetisnotavailableforcurvemixes.
If the master channel trim should also adjust the slave channel, set
Trim to Act. A channel monitor on the left side of the screen
shows how channels respond to input. To view a switch-assigned
mixonthemonitor,themixswitchmustbeintheactiveposition.