User manual

37SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL
EN
FUNCTION LIST
WhenusingacompatibleAS3Xreceiver(AR636,AR6335,
AR7350,AR9350,etc.),GainLiveViewallows
• RealtimedisplayofgainvaluesforRollPitchandYaw
• Allows gains to be adjusted from the roller
• Selectionofthechannelthatisusedtoadjustgains(mustmatch
application)
• Selection of the switch that is used to change flight modes
To activate AS3X Gain Live View:
1. In the telemetry screen in one of the empty positions select
AS3X and activate the Display. This will activate the AS3X Gain
menu in the Function List.
2. In the Function List Access the AS3X Gain menu. If an AS3X
receiver is bound to the transmitter and the receiver and
transmitter are on, live gain values will be displayed on this
screen.
Axis:RollPitchandYawgainaredisplayedtotherightofeachAxis
Rate: Rate gain values are displayed here
Heading: Heading gain values are displayed here
Actual: The current gain value is displayed here. Note that this value
takes into account the priority gain and the stick position of
that channel
Gain:Thisvaluerepresentsthepositionoftheinput(rollerorknob)
Input: Allows the selection of the roller to be used to adjust the gain
Channel: Must correspond to the channel selected in the AS3X
application in the FM Channel Assignment screen
FM Switch: Selects the switch on the transmitter that is used to
select the flight modes in the AS3X system
Notethatrelative(REL)mustbeselectedintheapplication’sgain
screen to allow adjustable gain from the transmitter.
Pleaseseethefollowingwebaddressforvideosandinformation
about setting up the AS3X application, Live View and adjusting the
gain from the transmitter.
http://www.spektrumrc.com/Technology/AS3X.aspx
AS3X Gain Live View (ACRO and SAIL Types only)
V-Tail Differential

Only available in Sailplane Type when V-Tail A or V-Tail B is active. See SAIL (Sailplane)sectionforsetup.
Camber Preset

Only available in Sailplane Type when a 2+ aileron wing type is selected. See SAIL(Sailplane)sectionforsetup.
Camber System

Only available in Sailplane Type when a 2+ aileron wing type is selected. See SAIL(Sailplane)sectionforsetup.
Flap System

Only available in Airplane Type when a flap-enabled wing type is selected. See ACRO(Airplane)sectionforsetup.
Pitch Curve

Only available in Helicopter Type. See HELI(Helicopter)sectionforsetup.
Swashplate

Only available in Helicopter Type. See HELI(Helicopter)sectionforsetup.
Gyro

Only available in Helicopter Type. See HELI(Helicopter)sectionforsetup.
Tail Curve

Only available in Helicopter Type. See HELI(Helicopter)sectionforsetup.
Motor Cut

Only available in Multicopter Type. See MULTI(Multicopter)sectionforsetup.
Motor Curve

Only available in Multicopter Type. See MULTI(Multicopter)sectionforsetup.
The following Function List options are only available when they are enabled from the Model Type screen.