User manual

21SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL
EN
In the Model Utilities function you can create a new model,
delete a model, copy a model, reset a model to default settings
and sort the model list.
Use this selection to create a new model in the model select list.
When adding a new model from the Model Select screen or Model
Utilities,thenewmodelcreatedisthesametypeofmodel(Acro,
Heli,SailorMulti)asthecurrentmodel.TheModelTypefunction
can still be used to change the type of the current model.
1. Select Create New Model. Within this screen, you will have the
option to create a new model or cancel.
2. If you select Cancel, the system will return to the Model Select
function.
3. If you select Create, the new model will be created and now be
available in the model select list.
SYSTEM SETUP
Model Utilities

Create New Model
Use this selection to permanently delete a model from the model
select list. If you do not wish to delete a model, select Cancel to
exitthepage.
1.Todeleteamodel,highlightthemodellisted.Presstoselect
thenrolltothemodelname.Pressthescrollwheeltoselect.
2. Select DELETE to delete the model.

Delete Model
The Model Copy menu enables you to duplicate model
programming from one Model List location to another.
Use Model Copy to:
• Saveadefaultmodelcopybeforeexperimentingwith
programming values
• Expediteprogrammingforamodelusingasimilar
programming setup
IMPORTANT: Copying a model program from one model memory
to another will erase any programming in the “To” model memory.
To copy model programming:
1. Make sure the model program you wish to copy is active. If the
desired model program is not active, select Cancel and change
the active model in the Model Select menu.
2.Selectthemodelmemorynextto“To”andscrolltothedesired
modelmemory.Pressthescrollwheeloncetosavetheselection.
3. Select Copy and the Confirm Copy screen appears.
4. Select Copy to confirm. Selecting Cancel will return to the
System Setup screen.
5.Selectthe“To”modelasthecurrentmodel,thenbindthe
transmitter and receiver. Copying a model does not copy the
bind from the original model.
You cannot use the Model Copy screen to copy model
programming to an SD Card. To copy model programming to the
SD Card, please see “Transfer SD Card” section on page 9.

Copy Model