User manual

16 SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL

Select from Airplane, Helicopter, Sailplane or Multicopter

model types.

IMPORTANT: When you select a new model type, you will delete

any programming data in the current model memory. Always

conﬁrm the desired model memory before changing model types.

It will be necessary to re-bind after resetting the model type.

To change the model type:

1. Scroll to the desired model type and press the scroll wheel.

The Conﬁrm Model Type screen appears.

2. Select Yes and press the scroll wheel to conﬁrm the model

type.Alldatawillbereset.SelectingNowillexittheConrm

Model Type screen and return to the Model Type screen.

PressandholdthescrollwheelwhilepoweringonthetransmittertoshowtheSystemSetuplist.Noradiotransmissionoccurswhena

System Setup screen is displayed, preventing accidental damage to linkages and servos during changes to programming.

You can also enter the System Setup from the Function list without turning the transmitter off. A Caution screen will appear that warns that

RFwillbedisabled(thetransmitterwillnolongertransmit).PressYES if you are sure and want to access the System List. If you are not

sure, press NOtoexittothemainscreenandcontinueoperation.

If you do not press YES or NO,thesystemwillexittothemainscreenandcontinueoperationwithinapproximately10seconds.

WARNING: Do not press YES unless the model is turned

off or the model is secured.

ModelSelectenablesyoutoaccessanyofthe250internalmodel

memory locations in the Model Select list.

1. Scroll to the desired model memory in the Model Select list.

2. When the desired model memory is highlighted, press the

scroll wheel once to select the model. The transmitter returns

to the System Setup List.

3. Add a new model by rolling to the bottom of the list. You will

then be prompted with the Create New Model screen, with

the option to create a new model or cancel. If you select

Cancel, the system will return to the Model Select function. If

you select Create, the new model will be created and now be

available in the model select list.

Direct Model Access

PresstheClearandBackbuttonsfromtheMainScreenora

telemetry screen to access Model Select.

SYSTEM SETUP

Model Select

Model Type