User manual

14 SPEKTRUM DX20 • TRANSMITTER INSTRUCTION MANUAL
EN
X-Plus Channels and Failsafe
FailsafeisnotsupportedforservosconnectedtotheX-Plus
Module. Nofailsafeshouldbeexpectedorattemptedforaservo
connectedthroughtheX-PlusModule. However, servos connected
totheX-PlusModulewillholdlastcommandintheeventofa
failsafe condition.
ToActivateX-Plus
1. Open the Frame Rate Menu in System Setup.
2.ScrolltoX-Plusandpressthescrollwheeltoactivate.TheX-
PlusInputsscreenisnowactiveintheChannelAssignmenu.
Ifyouselect11msframeratebeforeyouactivateX-Plus,the
transmitterrevertsto22msframeratewhenX-Plusisactive.
CAUTION: Do NOT connect throttle or any primary
controlsurfacetotheX-PlusModule.TheX-Pluschan-
nelsareintendedtobeusedforauxiliaryfunctionsonly.X-Plus
channelshavearesolutionof512andvariablelatencyfrom
22mstoabout88ms.WhenX-Plusisactive,therst10chan-
nels default to 22ms.
Refer to community.spektrumrc.com for more information
aboutX-Plusoptions.
from Channel Assign menu
X-PLUS