User Manual

EN
8
4. The flashing green LED corresponds to the selected channel. When the first
LED is flashing, the throttle channel is selected (Channel 1) .
5. Once the first four channels have been confirmed, the LEDs will indicate
channels 5 through 7. Reverse channels as necessary and confirm the
setting with the same process as the previous step.
6. After the last channel is confirmed, power the transmitter OFF to save the
settings and exit trim programming. After confirming all 7 channels with
button A, the system will automatically shut off.
During trim programming, the four green LEDs on the transmitter
will flash to indicate which channel is selected for reversing
Channel 1
Throttle*
Channel 2
Aileron
Channel 3
Elevator
Channel 4
Rudder
To reverse the selected channel,
press the right vertical trim up
(Elevator trim for Mode 2). If
you don‘t want to reverse the
selected channel, proceed to
confirming the direction.
To confirm the direction for
the selected channel, press
and hold the A button. The
setting will be saved and the
next channel will be selected.
Repeat the process through
the first four channels.
*Throttle Reversed Warning: The transmitter will emit a warning tone and display
flashing LEDs upon reversing the throttle, after powering the transmitter OFF and
back ON. Press and hold the bind button/ switch A to accept and clear the throttle
reversed warning.
Factory Reset: Power the transmitter on while holding the sticks down and
outward. The transmitter will emit a series of beeps and revert to factory settings.
IMPORTANT: Factory reset will restore all settings to factory default, losing any
settings programmed in the DXS.
Channel 5 Channel 6 Channel 7
The RGB LED
indicates servo
direction;
green for normal,
red for reverse