User Manual

Binding

The DXS and your receiver must be bound to each other before they will

operate. Binding is the process of teaching the receiver the speciﬁc code of the

transmitter so it will only connect to that speciﬁc transmitter.

1. Push and hold the bind button on the receiver while powering ON the

receiver. Release the bind button once the orange LED starts to ﬂash

continuously, indicating that the receiver is in bind mode. The AR410

receiver will also enter bind mode if you power ON the receiver and then

press the bind button before the receiver has connected to any transmitter.

2. With the throttle in the low position, push and hold the A button while turning

the transmitter ON to put the

transmitter in bind mode.

3. After you set up your model,

always rebind the transmitter

and receiver to set the desired

failsafe positions.

Transmitter Setup

The DXS transmitter has reversible channels with trim programming.

Trim programming is a special setup mode on the DXS transmitter. You can

only enter trim programming at power up. The DXS transmitter does not emit a

signal to the receiver during trim programming to prevent accidental operation.

Normal control operation will not resume until you power the transmitter OFF

and then back ON again normally.

Trim Programming

1. Conﬁrm the channel numbers that need to be reversed.

2. Power OFF the DXS transmitter and the receiver. Leave the aircraft powered

OFF during trim programming.

3. To enter trim programming mode, push and hold the elevator and throttle

trim buttons up awhile you power ON the DXS transmitter.

BIND Status DXS and AR410

Ready to Bind Flashing Orange LED

Bind Complete Solid Orange LED

The RGB LED on the transmitter

will illuminate green to indicate

the transmitter is in trim

programming mode.