User Manual

EN
12
Troubleshooting Guide
Problem Possible Cause Solution
Aircraft
will not
respond to
throttle but
responds
to other
controls
Throttle not at idle and/or throttle trim
too high
Reset controls with throttle stick and throttle
trim at lowest setting
Throttle servo travel is lower than 100%
Make sure throttle servo travel is 100%
or greater
Throttle channel is reversed
(With battery disconnected from aircraft) Reverse
throttle channel on transmitter
Motor disconnected from ESC Make sure motor is connected to the ESC
Aircraft
will not
Bind
(during
binding)
to trans-
mitter
Transmitter too near aircraft during
binding process
Move powered transmitter a few feet from
aircraft, disconnect and reconnect flight
battery to aircraft
Aircraft or transmitter is too close to large
metal object, wireless source or another
transmitter
Move aircraft and transmitter to another
location and attempt binding again
The bind plug is not installed correctly in
the bind port
Install bind plug in bind port and bind the
aircraft to the transmitter
Flight battery/transmitter battery charge
is too low
Replace/recharge batteries
Bind button not held long enough during
bind process
Power off and repeat bind process.
Aircraft
will not
connect
(after
binding)
to trans-
mitter
Transmitter too near aircraft during
connecting process
Move powered transmitter a few feet
from aircraft, disconnect and reconnect
flight battery to aircraft
Aircraft or transmitter is too close to
large metal object, wireless source or
another transmitter
Move aircraft and transmitter to another
location and attempt connecting again
Bind plug left installed in bind port
Rebind transmitter to the aircraft and remove
the bind plug before cycling power
Aircraft bound to different model
memory.
Select correct model memory on
transmitter
Flight battery/Transmitter battery
charge is too low
Replace/recharge batteries
Transmitter may have been bound
to a different aircraft using different
DSM protocol
Rebind aircraft to transmitter
Control
surface
does not
move
Control surface, control horn, linkage
or servo damage
Replace or repair damaged parts and
adjust controls
Wire damaged or connections loose
Perform a check of wires and connections,
connect or replace as needed
Transmitter is not bound correctly or
the incorrect model was selected
Rebind or select correct airplanes in
transmitter
Flight battery charge is low Fully recharge flight battery
BEC (Battery Elimination Circuit) of the
ESC is damaged
Replace ESC