iX12 Manual

The aircraft must be configured and binding complete prior to testing the
failsafe settings.
To test the function of the failsafe settings:
1. Power on the transmitter and receiver and confirm the controls function
properly.
2. Power off the RF signal on the transmitter by double clicking the power
button, switching off RF and touch and hold OK. The throttle and control
surfaces should immediately move to the expected failsafe positions or
hold position depending on the failsafe type set during bind. Throttle should
always be set to return to low throttle.
3. Restore the RF signal by double pressing the power button and selecting RF
on and touch and hold OK.
TOC