iX12 Manual
CHARGING
The initial charge time is approximately 6 hours. Charge the transmitter when
the low battery alarm sounds. See the System Settings section for information on
setting the low battery alarm level.
Always charge the transmitter on a heat-resistant surface.
Charging
1. Insert the USB cable into the power supply and connect it to an AC power source.
2. Insert the micro USB connector into the USB port on the transmitter.
3. The LED will flash blue to indicate the battery is charging. If charging
while the sytem is powered off, the LED will flash for approximately
10minutes and then power off.
4. Disconnect the transmitter from the charger when charging is complete
and disconnect the power supply from the power outlet.
CAUTION: Never leave a charging battery unattended.
TOC