iX12 Manual

The receiver enters failsafe
mode a short distance away
from the transmitter
Receiver antenna cut or damaged
Replace or contact Horizon
Product Support
Main and remote receivers
too near each other
Install main and remote
receivers at least 2 inches
(51mm) apart
Receiver stops responding
during operation
Low battery voltage
Completely recharge flight
battery
Loose or damaged wires or
connectors between battery
and receiver
Do a check of the wires and
connection between battery
and receiver. Repair or replace
wires and/or connectors
Receiver loses its bind
Bind button pressed before
transmitter powered on
Rebind by performing binding
instructions
Receiver slowly blinking at
landing (DSM2 Only)
Loss of power to the receiver
during flight
Check battery voltage
System powered on and connected,
then receiver powered off without
powering off transmitter
Power off the transmitter when
the receiver is powered off