iX12 Manual

Aircraft will not link
(after binding)
to transmitter
Transmitter too near aircraft
during linking process
Move powered transmitter
a few feet from aircraft,
disconnect and reconnect
flight battery to aircraft
Aircraft or transmitter is too
close to large metal object
Move the aircraft or transmitter
away from the large metal object
Bind plug left installed
in bind port
Rebind transmitter to the
aircraft and remove the bind
plug before cycling power
Aircraft is bound to different
model memory
Select the correct model
memory on transmitter
Flight battery/Transmitter
battery charge is too low
Replace/recharge batteries
Transmitter may have been bound
using different DSM protocol
Bind aircraft to transmitter
Damaged remote receiver or
receiver extension
Required remote receiver is
not connected