iX12 Manual

ADJUST THE GIMBAL CENTERING SCREW
When changing between Modes 1 and 2, or between Modes 3 and 4, the
gimbal centering screw must be adjusted on both gimbals to enable the
centering spring on the elevator gimbal and disable it on the throttle gimbal.
1. Use a small Phillips screwdriver to tighten the gimbal centering screw.
Tightening the screw will disengage the centering spring.
2. Using a small Phillips screwdriver, loosen the opposite gimbal centering
screw until the lever engages.
Centering
screw
Centering
screw
TOC