iX12 Manual

Each individual output channel can be mapped to any input channel from
the trainer signal, leaving all other controls on the instructor transmitter.
Primary flight control channels default to instructor control. Leave all channels
connected to flight controls set up as instructor when using a headtracker.
To configure headtracking FPV:
1. Select either Wired or Wireless Trainer from the Trainer menu.
2. Select the FPV trainer mode.
3. Select the switch to enable/disable the head tracker.
4. Select the first Output Channel is to be controlled. For example, if the pan
servo is plugged into channel 5, select channel 5 as the output. Each axis
of the gimbal will go to a seperate output channel.
5. Change the mode to STUDENT. This selection only applies to the selected
output channel.