iX12 Manual

In the default state, the kickpoint for the transition between positions 0 and
1 is at 75%. The kickpoint for the transition between positions 1 and 2 is at
-75% percent. The input is in switch position 1 at neutral (0%). Moving the
input above 75% will change it to position 0, and moving it below the -75%
value changes it to position 2.
Kickpoints can be assigned to any value between -100% and 100%, allowing
the kickpoints to be assigned as close to or as far apart as desired. The values
of the kickpoints determine where they trigger along the travel range. If the
values are the same, the switch output will skip position 1 and jump between
positions 0 and 2.