iX12 Manual

SAILPLANE PRE-CONFIGURED MIXES
When Sailplane is selected as the model type, the iX12 will pre-configure
four commonly used mixes. For the following mixes, it is normal to set the
offset close to or at the end point because of the geometry of sailplane flap
servo linkages. It is also normal to use a significant amount of trim on the flap
channels to center the control surfaces with these configurations.
Aileron to Rudder (AIL > RUD)
The Aileron to Rudder mix is commonly used for coordinated turns. When
active, as aileron is applied, the rudder moves in the same direction as the
turn (right aileron input results in right rudder output). If Switch is assigned
to Flight Mode, a second Switch option allows an additional switch to be
assigned to activate up to three aileron to rudder mixes for each flight mode.