DX6e Manual
5SPEKTRUM DX6e • TRANSMITTER INSTRUCTION MANUAL
EN
INSTALLING OPTIONAL LITHIUM ION BATTERY PACK
INSTALLING THE TRANSMITTER BATTERIES
1. Remove battery cover from the back of the transmitter.
2. Remove the AA battery holder and disconnect from the
transmitter power port.
3. Remove the Rectangle shaped foam and flat foam from the
battery compartment.
4. Connect the battery pack (SPMA9602) to the
transmitter power port.
5.InstalltheoptionalLithiumIonbatterypackintothe
transmitter.
6. Install the battery cover.
NOTICE: When installing a Lithium Ion battery pack, always set the
battery chemistry to Lithium Ion in the Systems Setting screen to
correctly set the low voltage alarm.
1. Remove battery cover from the back of the transmitter.
2. Install the included 4 AA batteries into the battery holder.
3. Install the battery cover.
The optional Li-Ion battery has an internal charger designed to
quickchargeatarateof0.5amps.Thechargeportonthebattery
is not polarity-dependent.
NOTICE:Neverconnectanexternalbatterychargertoyour
DX6e transmitter.
Always charge the transmitter on a heat-resistant surface.
1. Power off your transmitter.
2.Connectthepowersupply(SPM9551)connectortotheLi-Ion
charge port located under the rubber flap on the battery door.
3. Connect the power supply to a power outlet using the
appropriate adapter.
4. Disconnect the transmitter from the power supply once
charging is complete and disconnect the power supply from
the power outlet.
CAUTION: Never leave a charging battery unattended.
CAUTION: Never charge a battery overnight.
Battery Alarm
The System Settings Screen allows you to change the battery type
and low voltage alarm settings. See “System Settings” for more
information.
• An alarm will sound when the battery reaches the low voltage
limit (6.4V for LiPo/Li-Ion).
CAUTION: Never change the low voltage limit for
LiPo/Li-Ion batteries from 6.4V. Doing so could over-
discharge the battery and damage both battery and transmitter.
CHARGING THE LITHIUM ION BATTERY PACK